What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 16.06.2025 10:23

A fuse is a non-resetable over current circuit protector.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
(Dc diagram shown, AC is similar).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Here is a simplified AC power diagram.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Has anyone ever had sex with their cousin? How did it start, and would you do it again?
[image of Common-mode choke]
The bolt then partially travels down the line to your home.
These devices are installed between the “hot” and “neutral” and protective ground.
Why don't younger men like older women?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
He then describes Rainy Season and Lightning.
What are some ways to improve speed in sprinting, running uphill, and long/middle distance running?
In schematic diagrams this is the symbol for a fuse:
It also is a device that limits the change in current flow.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
At one ohm, the resistor has a maximum of 1 watt power.
This one hit behind the barn.
How was your JEE Advanced 2024 result?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
nine
so, what happens?
Why do many women wear sleeveless shirts, more so than men?
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
When the mind leaves the body - scientists investigate the incredible phenomenon of OBEs - Earth.com
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
what exactly is a ‘surge’ protector?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
the problem then depends on "how fast does the fuse operate?".
What makes a woman attractive?
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–14 [Omar Gharbi Omar Gharbi ]
One is “what exactly is in a ‘surge protector’ ? ”
There are three different concepts here that are getting confused.
[old diagram got deleted by accident]
Barnstars:
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
An AC voltage/ current source, and an ac inductive load.
This is where the MOV conducts again, and dissipated the energy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is 'the assistant's answer'
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Upvotes:
So, the voltage could go up to 500 volts, and the fuse will not open up.
The third is lightning and “how it gets conducted into a home.”
2024–10–10[John johnson John Johnson ]
a photo is worth a thousand words.
There are two important concepts here.
He then describes the function of a fuse.
For this case there are devices called Metal oxide varistors (MOV).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
I post the exact comment here.
Now when you have a certain ac resistance, then a current flows in a loop.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Edit 2024–10.
but I think this circuit , shows a few more pieces.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
One
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This device then solves the entire problem.
A circuit breaker is similar, but is resettable.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At least they know the answer if they wanted it.
but this device (an Inductor) … impedes the rapid changes in the current.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
But it can get overloaded, and no longer works.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
First Sentence:
But… the neutral is now “floating” because of the 1 ohm resistance.
It seems Mohan does not understand the difference between a comment and an Answer.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
He then asserts :
This is where this question deviates from being a 'generic' question, and becomes more specific.
What does a fuse do?
The MOV will conduct when the voltage exceeds 50% of line voltage.
What is lightning?
The other is “what does a “fuse” do?”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.